Backing Plates, Pkg of 10
Adhesive Test Jig and Anchor Plate
This Adhesive Test Jig and Anchor Plate were developed to enable the testing of adhesives or other uncured coatings. The process is as follows: Thread up to 5 pull stubs into the base of the Adhesive Test Jig. Apply the adhesive or coating to be tested to several pull stubs (up to 5 at a time). Place the coated pull stubs face-to-face with...
Aluminium Pull Stubs, 1/4" dia.
1/4 inch dia. pull-stub. Pk/100
Blue P.A.T.T.I.® to Piston Hose - 6 foot with fittings
This is a replacement hose used to attach the PATTI control module to the piston. The hose replaces the blue hose that originally came with your PATTI unit. The end connection fittings are included
Gasket for PATTI Pistons
Did you know the most common cause of unexpected results with the PATTI is poor gasket condition and/or lubrication? Replace your old gasket today and observe the improvement in your PATTI system! Our gaskets are made of an RTV material that is fairly resistant to abuse. However, should your gasket become chipped on the outer diameter or torn ...
P.A.T.T.I.® Air Pump
PATTI Air Pump, use in place of CO2 cartridges, non-hazardous and environmentally friendly! This item may be out of stock! Please call (301) 975-9798 prior to ordering.
P.I.P.S. (PATTI Instant Pull Stubs) was designed to help our customers who require a fast turnaround. These patented pull-stubs come with an adhesive that cures in five minutes using a high-intensity light which significantly reduces the curing time required by most epoxies. Our adhesive has a bond strength greater than 2,000 psi and works for m...
Each piston comes complete with the required gasket(s), prelubricated and installed! The F-8/12 (F-20) Piston, the largest piston we stock at SEMicro, is like having 3 pistons in 1: an F-8, an F-12 and combined as an F-20. This piston is great if you will be testing many different coatings with different adhesion characteristics. It provides th...
Short blue hose for fixed Piston connection - 4" long with fit
This is a replacement hose used for the fixed connection to the piston. This hose is only required if the short length of hose attached to your piston is leaking or has been separated from the piston and is lost. The end connection fittings are included.
Stand-Off Ring and Threaded Stud
Required if using larger than 1/2" diameter pull-stubs.